TOHATSU BFT75A Service Manual page 573

dummyhead dummyhead
CONTROLS
Set the steel ball [1] in the position as shown.
Apply marine grease to the pin of the throttle arm [2].
Apply marine grease to the throttle rod [3] at position as shown.
Set the two washers [4] and the throttle rod on the throttle arm, and install the E-ring [5] securely as shown.
Apply marine grease to the pivot points of the throttle arm.
Set the throttle arm in the cutout [6] in the guide plate [7] as shown.
Assemble the throttle arm/throttle rod assembly with the shift frame [8].
Set the throttle arm/throttle rod/shift frame assembly on the tiller handle [9] while aligning the steel ball with the
groove [10] in the housing.
Install the three bolts [11] and washers [12], and tighten them to the specified torque. Note that the throttle arm
does not interfere with the cutout in the guide plate.
TORQUE: 4.5 N·m (0.46 kgf·m, 3.3 lbf·ft)
Install and tighten the two bolt/washers [13] to the specified torque.
TORQUE: 7 N·m (0.71 kgf·m, 5.2 lbf·ft)
Tighten the nut [14] of the throttle rod to the specified torque.
TORQUE: 1.3 N·m (0.13 kgf·m, 1.0 lbf·ft)
Apply marine grease to the side and upper of the shift frame.
[11]
[12]
[6]
[7]
[14]
19-36
[3]
[2]
[4]
[1]
[4]
[5]
[13]
[8]
[10]
[9]
[1]