TOHATSU BFT75A Service Manual page 453

dummyhead dummyhead
GEAR CASE
Push the shift slider [1] into the propeller shaft [2]
slowly, and set the steel balls (#7) [3] in the positions
shown.
• Note that the shift rod cannot be installed unless the
shift slider is on the reverse side. Set the shift slider
on the reverse side securely.
Apply marine grease to outer circumference of a new
O-ring [1], and install it on the propeller shaft holder [2].
Apply gear oil to the ball bearings [3], and install them
on the propeller shaft [4].
Install the propeller shaft, taking care not to let the ball
bearings fall out of position.
Install the following:
– Propeller shaft holder (page 16-18)
– Water pump (page 11-9)
– Shift rod (page 16-16)
– Gear case (page 16-7)
– Propeller (page 16-3)
16-24
[2]
[3]
[4]
[3]
[1]
[2]
[1]