Chain Case/Cam Chain Removal; Installation - TOHATSU BFT75A Service Manual

dummyhead dummyhead
CYLINDER HEAD

CHAIN CASE/CAM CHAIN REMOVAL/

INSTALLATION

• Keep the magnetic parts away from the cam chain.
REMOVAL
Disconnect the battery negative (–) cable.
Make sure the remote control lever is in "N" (neutral)
position.
Remove the following:
– Engine cover
– Engine under cover (page 6-5)
– Cylinder head cover (page 14-15)
Put the No.1 piston at the top dead center of its
compression stroke by turning the alternator rotor
clockwise (page 3-12).
Remove the alternator (page 7-6).
Remove the fuel strainer (low pressure side) [1] from
harness clip bracket B [2], and release the tube joint [3]
from fuel tube clamp B.
Remove the two bolts [4] and remove the harness clip
bracket B.
Remove the bolt [1] and remove harness clip A [2].
Remove the two bolts [3], and remove harness clip
bracket C [4].
Remove the bolt [1], and remove connector bracket A
[2] from the chain case.
14-4
[4]
[1]
[2]
[1]
[3]
[2]
[1]
[2]
[3]
[4]