Shift Link Bracket Disassembly; Assembly - TOHATSU BFT75A Service Manual

dummyhead dummyhead

SHIFT LINK BRACKET DISASSEMBLY/

ASSEMBLY

Remove the shift link bracket (page 19-8).
(WASHER MATING SURFACE)
CHAMFER
(THROTTLE LINK
MATING SURFACE/
BEARING PORTION)
WASHER (6 mm)
BOLT (6 X 12 mm)
PIVOT WASHER
DETENT SPRING
BOLT (6 X 16 mm)
INSTALLATION:
Loosely tighten.
Install the shift link bracket,
check that the detent spring
roller is in the groove in the
shift arm securely, and then
tighten the loosely tightened
bolt securely.
E-RING (4 mm) (3)
INSTALLATION
DIRECTION:
(MATING SURFACE)
THROTTLE ARM
THROTTLE LINK
DETENT ASSISTED
SPRING
SHIFT LINK PIN
SHIFT SLIDE PIVOT
THROTTLE PLATE
(SLIDING SURFACE)
(SEAT)
SHIFT PIVOT PLATE
LINK PIN
E-RING (6 mm)
LINK PIN
CONTROLS
(MOUNTING
PORTION)
BUSHING A (2)
(SLIDING SURFACE)
(MOUNTING PORTION)
SHIFT LINK BRACKET
WASHER (8 mm)
19-13