TOHATSU BFT75A Service Manual page 257

dummyhead dummyhead
ENGINE COVER
Install the L. engine under cover [1] on the engine side
stoppers [2].
Pull out the power trim/tilt switch wire through the top of
the R. engine under cover.
Align the R. engine under cover installation groove [1]
with the under cover seal A [2] of the mount case as
shown, and install the R. engine under cover [3] on the
outboard motor from the top of the outboard motor.
Be sure that the tube (8 x 300 mm) with the water
mount nut is on the outside of the R. engine under
cover.
Install the R. engine under cover [1] on the engine side
stopper [2].
6-8
[2]
[2]
[1]
[2]
[1]
[1]
[3]