TOHATSU BFT75A Service Manual page 406

dummyhead dummyhead
Remove the crankcase [1] and oil seal [2] from the
cylinder block [3].
Check the lower main bearings [1] for damage (scores,
scratches, etc.) before removing them. Replace the
lower main bearings if necessary.
Remove the five lower main bearings from the
crankcase.
• Store the removed lower main bearings separately
for each main journal.
Check that the piston is at bottom dead center of its
stroke. If not, move the piston to bottom dead center by
turning the crankshaft.
Remove the connecting rod bolts [1] and the connecting
rod cap assembly [2].
Check the connecting rod bearing [3] for damage
(scores, scratches, etc.) before removing it. Replace
the connecting rod bearings if necessary.
Remove
connecting rod cap.
• Store the connecting rod cap and connecting rod
bearing separately for each cylinder.
the connecting rod bearing
[2]
[3]
[2]
[3]
from the
CYLINDER BLOCK
[1]
[1]
[1]
15-5