Removal Of Propeller Shaft Housing Assy; Disassembly Of Propeller Shaft Housing Assy - TOHATSU MFS 25D Service Manual

Lower Unit

12) Removal of Propeller Shaft Housing Assy

1. Remove the propeller shaft assy.
Use a plastic hammer to remove the assy if
it cannot be removed by inserting a flathead
screwdriver or the like.
2. Hold the propeller shaft and fully pull out the propeller
shaft housing assy.
When pulling out the propeller shaft housing assy,
remove the clutch push rod together with the
housing assy, being careful not to let it fall.

13) Disassembly of Propeller Shaft Housing Assy

Do not reuse a removed bearing.
1. Tighten the universal puller plate to create a gap between
the bevel gear C and propeller shaft housing.
Universal Puller Plate:
P/N. 3AC-99750-0
2. Remove the bevel gear C by putting two flathead
screwdrivers into the gap to pry the gap open.
6-16
CAUTION
4st 25/30 2022