TOHATSU BFT75A Service Manual page 350

dummyhead dummyhead
ENGINE REMOVAL
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when
handling fuel.
• Keep heat, sparks, and flame away.
• Wipe up spills immediately.
• Handle fuel only outdoors.
Remove the following:
– Battery negative (-) cable
– Engine cover
– L./R. engine under cover (page 6-5)
– Under cover front bracket (page 6-12)
– Under cover rear bracket (page 6-15)
– Gear case/extension separator (XRT type only)
(page 16-5)
– Starter cable/fuse cable(page 10-6)
– Shift link bracket/neutral switch (page 19-8)
– Seal holder (page 19-12)
Hook the engine hanger (commercially available:
VSB02C000021) hooks [1] on the two engine hangers
and secure the engine so it does not fall.
Remove the following:
– Extension case/lower rubber mount (page 16-9)
– Oil case (page 12-5)
Relieve the fuel pressure according to the fuel pressure
relief procedure (page 5-66)
Remove the bolt [1], and disconnect the fuel hose [2]
and fuel pipe joint [3] from the vapor separator.
Remove the O-rings [4] from the fuel pipe joint.
Disconnect the pressure regulator control tube [5] and
vinyl tube [6] from the intake manifold [7].
Release the pressure regulator control tube from tube
clamp D [8].
Release the water level sensor 2P connector [1] and
trim angle sensor 3P connector [2] from the relay
bracket [3].
Release the harness band clip [4] from the relay
bracket.
ENGINE REMOVAL/INSTALLATION
[1]
[7]
[5]
[8]
[3]
[2]
[1]
[4]
[6]
[4]
[3]
[1]
[2]
13-3