Power Trim/Tilt/Swivel Case; (Except Lhgx Type) - TOHATSU BFT75A Service Manual

dummyhead dummyhead
TRIM/TILT
POWER TRIM/TILT/SWIVEL CASE REMOVAL/INSTALLATION

(EXCEPT LHGX TYPE)

REMOVAL
Remove the following
– Engine (page 13-3)
– Mount (page 17-2)
Connect the battery positive (+) cable to the Green
terminal [1] of the power tilt motor 2P connector [2] and
the battery negative (-) cable to the Blue terminal [3].
Raise the swivel case to the uppermost position (the
position rod of the power trim/tilt is extended fully).
• Connect the power tilt motor 2P connector to the
battery with care no to short-circuit it.
After raising the swivel case to the uppermost position,
disconnect the battery cables from the connector
terminals, and secure the swivel case using the tilt
stopper.
Open the wire harness clip [1] and release the trim
angle sensor wire and the power tilt motor wire.
Remove the spiral tube [2] from the trim angle sensor
wire and the power tilt motor wire.
Remove the tie-wrap band [1] from the under case
grommet C [2], and remove the trim angle sensor wire
[3] and power tilt motor wire [4] out of the hole in the
under cover front bracket.
Remove the motor wire bushing [1] from the L. stern
bracket [2].
18-6
[1]
[2]
[3]
[1]
[2]
[3]
[1]
[2]
[2]
[1]
[4]