Installation - TOHATSU BFT75A Service Manual

dummyhead dummyhead

INSTALLATION

Tilt up the outboard motor and hold it in position by
hooking the engine hanger chain on each of the two
engine hangers.
Apply marine grease to the inner surface of the water
tube grommet [1], and install it on the water tube [2].
Connect the water tube to the oil case, noting the
installation direction as shown.
Set the water tube plate [3] and tighten the bolt [4].
Install the under cover rubber [1] to the extension case
[2].
• Install the under cover rubber under the projection
[3] on the extension case.
Apply marine grease to the inner surface of the
extension case grommet [4] and install it to the
extension case.
Install the two dowel pins [5].
Install the lid clip [6] on the extension case, and check
that the clip seat is in contact with the extension case.
[3]
[4]
[3]
[1]
[4]
[6]
GEAR CASE
[1]
[2]
[2]
[5]
16-11