Assembly - TOHATSU BFT75A Service Manual

dummyhead dummyhead

ASSEMBLY

Set the four brush springs [1] and brush sets [2] into the
brush holder [3].
Install the plate [4] on the brush holder and secure it
with the clip [5].
Apply grease to the internal gear [1], inner wall of the
overrunning clutch [2], gear shaft [3] outer surface, and
whole surface of the gear shaft stopper [4].
Assemble the overrunning clutch, gear shaft, and the
gear shaft stopper with the internal gear.
Install a new snap ring [5].
Holding the overrunning clutch, push the gear shaft into
the overrunning clutch. Push the gear shaft stopper up
to set the snap ring in the groove of the gear shaft
stopper securely.
STARTING SYSTEM
[1]
[5]
[4]
[2]
[3]
[5]
[4]
[4]
[2]
[3]
[5]
[1]
9-15