TOHATSU BFT75A Service Manual page 574

dummyhead dummyhead
Apply marine grease to the indicated position of the
housing [1] and to the outer surface of the bushing [2],
and then install the bushing on the housing.
Apply marine grease to the new O-ring [3] and install it
on the shift lever [4].
Apply marine grease to the sliding surfaces of the shift
lever and lever stopper [5].
Install the shift lever and the lever stopper, aligning the
square parts of both the shift lever and lever stopper
with the square holes in the shift gear as shown.
Install the socket bolt [6] and washer [7] and tighten it.
Install the cap [8] on the housing.
• Except LHGX type:
Install the switch holder [1] on the power trim/tilt switch
[2] with the "UP" mark [3] on the power trim/tilt switch
toward the bolt installation hole [4] in the switch holder
as shown.
Install the switch grommet [5] on the power trim/tilt
switch.
Install the power trim/tilt switch, bolt [6], and washer [7].
Tighten the bolt to the specified torque.
TORQUE: 4.5 N·m (0.46 kgf·m, 3.3 lbf·ft)
• Check that the power trim/tilt switch wire does not
interfere with the throttle rod and the bolt.
Install the wire cover [8], and tighten the two screws [9].
Set the two new harness bands [10] in the recess on
both ends of the wire cover, and secure the power trim/
tilt switch wire and the wire cover together using the
harness bands.
Cut off the excess of each band so it does not interfere
with a neighboring part.
• LHGX type only:
Set the switch hole grommet [11] on the switch holder.
Install the switch holder, bolt, and washer.
Tighten the bolt to the specified torque.
TORQUE: 4.5 N·m (0.46 kgf·m, 3.3 lbf·ft)
[8]
[6]
[7]
[5]
[1]
[2]
[3]
[1]
[4]
[2]
[3]
[8]
[6]
[7]
[1]
[2]
[5]
CONTROLS
[4]
[5]
[9]
[10]
[11]
19-37