TOHATSU BFT75A Service Manual page 560

dummyhead dummyhead
TILLER HANDLE DISASSEMBLY/ASSEMBLY
DISASSEMBLY
Remove the tiller handle (page 19-21).
Remove the six screws [1] and under cover [2].
Remove the grommet [1] from the tiller handle.
Remove the two E-rings [2] from each of the two remote
control cables [3], and disconnect the remote control
cables from the throttle arm and the shift frame.
Remove the two bolt/washers [4] and remove the cable
bracket [5] and clamp bracket [6].
Open the harness band clip [1] that clamps tube B [2].
Remove tube B and disconnect the three power trim/tilt
switch connectors (Except LHGX type) [3].
Disconnect the two emergency stop switch connectors
[4].
[1]
[4]
[6]
[1]
[4]
[3]
CONTROLS
[2]
[5]
[1]
[3]
[2]
[2]
19-23