TOHATSU BFT75A Service Manual page 577

dummyhead dummyhead
CONTROLS
Apply marine grease to the side and outer surface of the steering handle bushings [1] and to the inner wall of
the housing.
Install the steering handle bushings on the tiller handle.
Apply marine grease to the washer (large) [2].
Set the washer (large) in the position shown, and install the steering bracket [3] on the tiller handle.
Apply marine grease to the wave washer [4].
Install the washer (small) [5], bolt [6], distance collar [7], wave washer and the nut (large) [8], and tighten the
bolt to the specified torque.
TORQUE: 29 N·m (3.0 kgf·m, 21 lbf·ft)
• Check that the threads of the bolt are not contaminated with marine grease.
Install the nut (small) [9].
Holding the bolt, tighten the nut (small).
Set the height adjusting block [10] and bolt [11] on the steering bracket, and tighten the bolt.
[10]
[11]
Install the indicator light [1] on the tiller handle so the display appears as shown.
• Install the indicator light by pushing the frame [2] on both ends of the display. Do not install the indicator light
by pushing the center of the display.
• After installation, check that the retaining tabs [3] of the indictor light are locked on the tiller handle securely.
19-40
[8]
[9]
[2]
[1]
[7]
[4]
[1]
[3]
[3]
[5]
[6]
[2]