TOHATSU BFT75A Service Manual page 278

dummyhead dummyhead
Set the main wire harness band clip [1] on the
electronic parts case.
Install the ECM [1] and two bolts [2].
Tighten the bolts to the specified torque.
TORQUE: 5 N·m (0.51 kgf·m, 3.7 lbf·ft)
Install harness clip bracket C [1] and two bolts [2] to the
chain case [3].
Tighten the bolts.
Clean the bolt/washer [1], the threaded part of the
alternator rotor [2], and the threaded part of the
crankshaft [3] with the clean shop towel or equivalent.
Apply engine oil to the threads and seat of the bolt/
washer.
CHARGING SYSTEM
[1]
[2]
[2]
[3]
: Clean thoroughly
: Apply engine oil
[1]
[2]
[3]
[1]
[1]
7-11