TOHATSU BFT75A Service Manual page 277

dummyhead dummyhead
CHARGING SYSTEM
Set the stator harness [1] on the chain case [2] and
electronic parts case [3] as shown.
Install harness clip bracket E [4] and tighten the bolt [5].
Route the stator harness [1] through the gap between
the electronic parts case [2] and main wire harness [3]
as shown.
Set the stator harness [1] on the projection [2] of the
electronic parts case as shown.
Connect the stator 3P connector [1] and set the stator
harness [2] on the electronic parts case [3].
Set the harness band clip [4] on the electronic parts
case.
7-10
[3]
[4]
[1]
[3]
[2]
[2]
[4]
[2]
[3]
[1]
[5]
[2]
[1]
[1]