Installation - TOHATSU BFT75A Service Manual

dummyhead dummyhead
CONTROLS

INSTALLATION

Set the steering bracket [1] of the tiller handle [2] on the mount frame [3] and install the two washers [4] and two
bolts [5]. loosely tighten the bolts.
Apply marine grease to the seating area (at two places) of the steering friction rod [6]. Install the steering friction
rod on the steering bracket and the steering friction shaft as shown. Note the installation direction of the
steering friction rod.
Install and tighten the bolts.
Steering bracket
side
Short
[6]
Steering friction
shaft side
Install the two washers [1] and two self-locking nuts [2].
Tighten the self-locking nuts.
• Note that the steering friction rod [3] installation
position varies, depending on the installation
direction of the steering friction shaft [4] (page 19-
20).
Install the control cables (page 19-5).
19-22
[3]
[6]
Long
[1]
[4]
[1]
[2]
[4]
[5]
[2]
[1]
[3]
[2]