TOHATSU BFT75A Service Manual page 530

dummyhead dummyhead
Remove the two E-rings [1], and upper cylinder pin [2].
Remove the self-locking nut [1] from the tilting shaft.
While holding the gas assisted damper [2], remove the L. stern bracket [3] and wave washer [4].
Remove the gas assisted damper and wave washers [5].
Remove the lower cylinder collar [6] and spacers [7].
Check the upper cylinder bushings [8] and lower cylinder bushings [9]. Replace the upper and lower cylinder
bushings with new ones if they are worn, damaged, or deformed.
• Store the gas assisted damper while holding it upright with the upper cylinder pin installation part up.
[3]
[1]
[4]
[5]
[7]
[2]
[1]
[8]
[5]
[7]
[9]
[9]
[2]
TRIM/TILT
[1]
[6]
18-49