Front Separate Cover Removal; Installation - TOHATSU BFT75A Service Manual

dummyhead dummyhead
ENGINE COVER
FRONT SEPARATE COVER REMOVAL/INSTALLATION
REMOVAL
Remove the engine cover.
Remove the bolt [1], special bolt (6 x 17 mm) [2], special bolt (6 x 37 mm) [3] and, front separate cover [4].
[2]

INSTALLATION

Install the front separate cover [1] on the outboard
motor and loosely tighten the bolt [2], special bolt (6 x
17 mm) [3], and special bolt (6 x 37 mm) [4].
• Make sure that the shoulder on each special bolt
goes into hole on the front separate cover.
Tighten each bolt to the specified torque in the
numbered order shown.
TORQUE:
Special bolt: 10 N·m (1.0 kgf·m, 7 lbf·ft)
bolt: 5 N·m (0.51 kgf·m, 3.7 lbf·ft)
Install the engine cover.
6-4
[3]
[1]
[1]
[3]
3.
1.
[4]
[4]
[2]
2.