TOHATSU BFT75A Service Manual page 452

dummyhead dummyhead
With the "F" mark [1] on the clutch shifter toward the
forward bevel gear (i.e. toward front), assemble the
clutch shifter with the propeller shaft while aligning the
shifter pin installation hole [2] with the long slot [3] in the
propeller shaft.
Install the shifter pin [1] while aligning the hole [2] in the
clutch shifter with the hole [3] in the shifter slider.
Install the cross pin ring [1] on the clutch shifter [2].
• Check that the coils of the cross pin ring do not
overlap each other.
Forward bevel
gear side:
Forward bevel
gear side:
[2]
[3]
[1]
[2]
GEAR CASE
Reverse bevel
gear side:
[1]
[2]
[3]
[1]
16-23