TOHATSU BFT75A Service Manual page 41

dummyhead dummyhead
SERVICE INFORMATION
LOCATING BAND
Set the water level sensor wire so the
locating band is above the harness clip
as shown.
HARNESS CLIP
WATER LEVEL
SENSOR WIRE
UNDER COVER
FRONT BRACKET
2-22
RELAY
BRACKET
TIE-WRAP BAND
(Except LHGX type)
Cut the band end.
TRIM ANGLE
SENSOR WIRE
(Except LHGX type)
LOCATING BAND
Set the water level sensor wire so
the locating band is above clip C.
CLIP C
UNDER COVER
GROMMET C
(Except LHGX type)
WATER LEVEL
SENSOR 2P
CONNECTOR
TRIM ANGLE SENSOR
3P CONNECTOR
(Except LHGX type)
POWER TILT MOTOR WIRE
(Except LHGX type)
Align the lower end of the
tape with the upper end of
grommet C
TAPE