Swivel Case/Mount Frame Disassembly/Assembly - TOHATSU BFT75A Service Manual

dummyhead dummyhead

SWIVEL CASE/MOUNT FRAME DISASSEMBLY/ASSEMBLY

DISASSEMBLY
Remove the swivel case/stern bracket (page 18-6).
Remove the external circlip [1] from the swivel shaft.
Mark [1] the mount frame [2] so that it aligns with the
" " mark [3] on the lower mount center housing [4].
Warm up the lower mount center housing [1] and mount
frame [2] using a heat gun (ETB1600: commercially
available) [3].
• Wear gloves to protect your hands when handling
the lower mount center housing.
Screw in the shaft of the bearing puller (commercially
available: OTC 1035) [4] and remove the lower mount
center housing.
TOOL:
Puller adapter [5]
• If it is hard to remove the lower center housing, heat
the lower mount center housing and mount frame
again.
[4]
07APF-ZY3A200
[5]
[4]
TRIM/TILT
[1]
[3]
[1]
[1] [3]
[2]
18-15
[2]