Eop Sensor Removal/Installation; Knock Sensor Removal/Installation; Ebt Sensor Removal/Installation - TOHATSU BFT75A Service Manual

dummyhead dummyhead
FUEL SYSTEM
EOP SENSOR REMOVAL/
INSTALLATION
Remove the intake manifold (page 5-69).
Disconnect the EOP sensor 3P connector [1] from the
EOP sensor [2].
Apply engine oil to a new O-ring [3] and install on the
cylinder block.
Install the EOP sensor and tighten to the specified
torque.
TORQUE:
• Be sure to use a torque wrench to tighten the switch.
Overtightening will damage the cylinder block.
Connect the EOP sensor 3P connector.
Install the intake manifold (page 5-71).
KNOCK SENSOR REMOVAL/
INSTALLATION (BF90D/BF100A ONLY)
Remove the intake manifold (page 5-69).
Disconnect the knock sensor 1P connector [1] from the
knock sensor [2].
Install the knock sensor and tighten to the specified
torque.
TORQUE:
Connect the knock sensor 1P connector.
Install the intake manifold (page 5-71).
EBT SENSOR REMOVAL/
INSTALLATION
Remove the following:
– Engine cover
– L. engine under cover (page 6-5)
Disconnect the EBT sensor 2P connector [1] from the
EBT sensor [2].
Remove the EBT sensor.
Apply engine oil to a new O-ring [3] and install on the
EBT sensor.
Apply liquid sealant (Threebond
equivalent) to the threads and seating surface of the
EBT sensor.
Install the EBT sensor and tighten to the specified
torque.
TORQUE:
Connect the EBT sensor 2P connector.
Install the following:
– L. engine under cover (page 6-7)
– Engine cover
5-84
22 N·m (2.2 kgf·m, 16 lbf·ft)
31 N·m (3.2 kgf·m, 23 lbf·ft)
®
1201, 1215 or
12 N·m (1.2 kgf·m, 9 lbf·ft)
[3]
[1]
[2]
[1]
[1]
[2]
[2]
[3]