TOHATSU BFT75A Service Manual page 387

dummyhead dummyhead
CYLINDER HEAD
Tap on the valve stem head [1] lightly with a plastic
hammer [2] two or three times, and set the valve stem
and valve keepers in the proper position securely.
• Tap straight down on each valve stem head. Take
care not to bend the valve.
• Support the cylinder head with a suitable material to
prevent damage to the valve.
Install the fuel pump lifter [1] in the cylinder head
assembly.
Install the cam pulser plate [1] on the camshaft [2],
aligning the projection [3] on the cam pulser plate with
the recess [4] in the camshaft.
Apply molybdenum disulfide oil to the camshaft journal,
cam face and the thrust area.
Install the camshaft from the oil pump side of the
cylinder head assembly.
Tighten the cam pulser plate bolt [5] to the specified
torque against the camshaft.
TORQUE:
14-28
34 N·m (3.5 kgf·m, 25 lbf·ft)
[1]
[2]
[1]
[5]
[4]
[3]
[1]
[2]
[1]