TOHATSU BFT75A Service Manual page 279

dummyhead dummyhead
CHARGING SYSTEM
Install the alternator rotor [1] on the crankshaft, and
loosely tighten the bolt/washer [2].
• Note that the alternator rotor has very strong
magnetic force. Hold the alternator rotor [3] by the
pulley during installation and removal and do not
hold it by the rotor pulser plate [4] so you don't pinch
your fingers with the rotor.
Torque the bolt/washer to the specified torque to seat
the alternator rotor, and then loosen the bolt.
TOOLS:
Pulley holder attachment,
hex 50 mm [1]
Holder handle [2]
TORQUE: 187 N·m (19.1 kgf·m, 138 lbf·ft)
Torque the bolt/washer to specified torque.
Tighten the bolt/washer an additional 90°.
TORQUE: 37 N·m (3.8 kgf·m, 27 lbf·ft) + 90°
Apply engine oil to a new O-ring [1], and install it on the
CKP sensor [2].
Install the CKP sensor on the chain case [3], and
tighten the bolt [4].
Connect the CKP sensor 3P connector.
Install the following:
– Alternator cover (page 7-5)
– Engine cover
7-12
[3]
070PB-0010100 or
07NAB-001040A
07JAB-001020A
[4]
[2]
[1]
[2]
[2]
[1]
[1]
[4]
[3]