Ckp Sensor Removal/Installation; Cmp Sensor Removal/Installation - TOHATSU BFT75A Service Manual

dummyhead dummyhead
Remove the three bolts [1] and remove harness clip
bracket D [2], VTEC solenoid valve [3], gasket [4], and
the filter [5].
• Check the filter. If it is restricted, replace the engine
oil and oil filter.
Install a new gasket and filter on the VTEC solenoid
valve.
Install the VTEC solenoid valve, and harness clip
bracket D and tighten three bolts.
Connect the VTEC solenoid valve 1P connector, and
install it on the connector bracket.
Set the harness band clip on harness band clip bracket
D and close the harness clip.
Install the following:
– L. engine under cover (page 6-7)
– Engine cover
CKP SENSOR REMOVAL/
INSTALLATION
Disconnect the battery cable from the battery negative
(–) terminal.
Remove the following:
– Engine cover
– Alternator cover (page 7-5)
Disconnect the CKP sensor 3P connector [1] from the
CKP sensor [2].
Remove the bolt [3] and remove the CKP sensor.
Apply engine oil to a new O-ring [4] and install on the
CKP sensor.
Install the CKP sensor, and tighten the bolt.
Connect the CKP sensor 3P connector.
Install the following:
– Alternator cover (page 7-5)
– Engine cover
CMP SENSOR REMOVAL/
INSTALLATION
Remove the following:
– Engine cover
– R. engine under cover (page 6-5)
Disconnect the CMP sensor 3P connector [1] from the
CMP sensor [2].
Remove the bolt [3] and remove the CMP sensor.
Apply engine oil to a new O-ring [4] and install on the
CMP sensor.
Install the CMP sensor, and tighten the bolt.
Connect the CMP sensor 3P connector.
Install the following:
– R. engine under cover (page 6-7)
– Engine cover
[4]
[1]
[2]
[1]
[3]
[3]
[1]
FUEL SYSTEM
[5]
[3]
[4]
[2]
[2]
[4]
5-83