TOHATSU BFT75A Service Manual page 386

dummyhead dummyhead
Install the valve spring [1] and valve spring retainer [2].
• Do not confuse the intake valve spring and the
exhaust valve spring.
IDENTIFICATION:
The intake side can be identified by the blue paint on
the spring.
The exhaust side can be identified by the white paint.
INSTALLATION DIRECTION:
Install the valve spring with the painted side toward the
valve spring retainer, and with the narrow pitch side [3]
of the coil toward the valve spring seat [4].
Using the special tool, compress the valve spring and
set the two valve keepers [1] in the groove in the valve
stems securely.
• To facilitate installation of the valve keepers, apply a
small amount of grease to the valve keepers and
push them in the groove in the valve stem.
TOOL:
Valve spring compressor [2]
[1]
[2]
[1]
[4]
07757-0010000
CYLINDER HEAD
PAINT
[2]
[1]
[3]
14-27