Gear Case/Extension Separator; (Xrt Type Only) Removal - TOHATSU BFT75A Service Manual

dummyhead dummyhead
GEAR CASE/EXTENSION SEPARATOR (XRT TYPE ONLY)
REMOVAL/INSTALLATION
REMOVAL
Remove the propeller (page 16-3).
Move the shift to the "N" (Neutral) position.
Tilt up the outboard motor to the uppermost position.
Pull the tilt stopper down to secure the outboard motor.
Remove the socket bolt [1], gear case cover B [2], and
distance collar [3].
Remove the four bolt/washers [1], bolt [2], washer
[3] and gear case [4] (LRT/LHT/LHG type).
Remove the five self-locking nuts, five washers, and
gear case (XRT type).
Remove the two dowel pins [5].
Remove shift rod A [1] from the shift shaft [2].
Pull the tilt stopper up and tilt the outboard motor down
to the lowest position.
[1]
[5]
[4]
[2]
[2]
GEAR CASE
[3]
[2]
[1]
[3]
[1]
16-5