TOHATSU BFT75A Service Manual page 505

dummyhead dummyhead
TRIM/TILT
Remove the three oil tank mounting bolt/washers (6 x 8
mm) [1] and oil tank [2] from the cylinder. Remove the
O-ring [3] from the cylinder.
Drain the residual ATF from the oil tank.
Remove the four power tilt motor mounting bolt/
washers (6 x 34 mm) [1] and power tilt motor [2] from
the pump.
Remove the O-ring [1] from the power tilt motor [2].
Remove the drive joint [1] and filter B [2] from the pump
[3].
Check the mesh of filter B for blockage and tears.
If it is torn, replace filter B with a new one.
If it is clogged with dust and dirt, blow the mesh with air
to remove the blockage.
Take care not to damage the mesh.
18-24
[3]
[1]
[1]
[2]
[2]
[1]
[2]
[1]
[2]
[3]