Installation - TOHATSU BFT75A Service Manual

dummyhead dummyhead

INSTALLATION

Move the shift to the "N" (Neutral) position.
Check that the shift rod [1] in the gear case is in the "N"
(Neutral) position.
• Check whether the cutout [2] of the shift rod spline
faces in the direction shown. [It indicates that the
shift rod is in the "N" (Neutral) position.]
If the cutout [1] of the shift rod spline is not in the
direction shown, protect the spline with a shop towel or
equivalent material [2] and turn the shift rod right and
left with a wrench until the cutout faces in the direction
shown.
Tilt up the outboard motor to the uppermost position.
Pull the tilt stopper down to secure the outboard motor.
Apply marine grease to the spline [1] of shift rod A [2].
Securely install shift rod A by aligning the cutout [3] on the spline of shift rod A with the projection [4] on the shift
shaft. Check that the cutout on the spline of shift rod A faces in the forward cruising direction [5].
[5]
[4]
[2]
CRUISING
DIRECTION
[3]
[1]
[2]
GEAR CASE
[1]
[1]
[2]
16-7