TOHATSU BFT75A Service Manual page 535

dummyhead dummyhead
TRIM/TILT
Install the E-ring [1] in the upper cylinder pin [2].
Apply marine grease to the outer surface of the upper
cylinder pin.
Apply marine grease to the outer surface of the lower
cylinder collar [3], and install it in the gas assisted
damper [4].
Apply marine grease to the inner wall of the spacers [5]
and install them on the lower cylinder collar.
Apply marine grease to the wave washers [6].
Align the holes of the upper mount of the gas assisted
damper and wave washers with the hole in the swivel
case.
Insert the upper cylinder pin into the hole and install the
E-ring [7] in the groove on the other end of the upper
cylinder pin.
Apply marine grease to the shaft installation part on the
L. stern bracket [1].
Apply marine grease to the wave washer [2] and install
it on the tilting shaft.
Install the L. stern bracket on the tilting shaft.
Loosely tighten a new self-locking nut [3] on the tilting
shaft.
18-54
[2]
[1]
[6]
[4]
[2]
[3]
[1]
[7]
[3]
[5]