Rigging
r/ in
9. Installation of the Trim
Sensor
1.
Tilt the engine up fully and secure it with the tilt stopper.
• Do not insert your hand or finger between
t h e o u t b o a r d m o t o r a n d t h e c l a m p
bracket while working.
• When attaching or detaching the PT
unit without removing the power unit,
s u s p e n d a n d s u p p o r t t h e o u t b o a r d
motor with a hoist etc. If not, it may be
dangerous as the outboard motor may fall
down.
2.
Pass the trim sensor wiring through the hole in the clamp
bracket and attach the trim sensor to the clamp bracket
using 2 bolts.
The trim sensor is easier to install if it is held in
place with a tie wrap.
10-20
WARNING
4st 25/30 2022