Example For Configuring Vpls Over Te In Martini Mode - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN

7.13.3 Example for Configuring VPLS over TE in Martini Mode

Networking Requirements
Figure 7-14 Networking of VPLS over TE in Martini mode
PE1
GE2/0/0
VLANIF10
As shown in
MPLS backbone network through PE1 and PE2. OSPF is used as the IGP protocol on the MPLS
backbone network.
It is required that VPLS in Martini mode and the dynamic signaling protocol RSVP-TE be used
to establish an MPLS TE tunnel between PE1 and PE2 to carry VPLS services.
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Issue 01 (2011-07-15)
#
return
Loopback1
1.1.1.9/32
GE1/0/0
VLANIF20
100.1.1.1/24
GE1/0/0
VLANIF20
100.1.1.2/24
MPLS TE Tunnel
GE1/0/0
VLANIF10
10.1.1.1/24
CE1
Figure 7-14, CE1 and CE2 belong to the same VPLS. They are connected to the
Configure a routing protocol on the devices (PEs and the P device) on the backbone network
to make them reachable, and enable MPLS.
Establish an MPLS TE tunnel and create a tunnel policy.
Enable MPLS L2VPN on PEs.
Create VSIs on PEs, specify LDP as the signaling protocol, and bind VSIs to the related
AC interfaces.
Configure VSIs to use the MPLS TE tunnel.
OSPF areas enabled with MPLS TE
Names and IDs of VSIs
IP addresses of peers and tunnel policy
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Loopback1 Loopback1
2.2.2.9/32
GE2/0/0
VLANIF30
100.2.1.1/24
GE1/0/0
VLANIF30
P
100.2.1.2/24
GE1/0/0
VLANIF40
10.1.1.2/24
7 VPLS Configuration
3.3.3.9/32
PE2
GE2/0/0
VLANIF 40
CE2
744