Example For Configuring Dual-System Hsb Between S9700S - Huawei S9700 Series Configuration Manual

S9700 Core Routing Switch
Configuration Guide - SPU

7.5.2 Example for Configuring Dual-System HSB Between S9700s

This section describes how to configure dual-system HSB between S9700s to improve the
service reliability.
Networking Requirements
A firewall board is treated as an independent device. As shown in
SPU A and SPU B are installed on two different S9700s and are connected to interfaces GE
2/0/13 of LPU A and LPU B through cables to implement the dual-system HSB function.
Issue 01 (2012-03-15)
dot1q termination vid 11
dot1q vrrp vid 11
ip address 11.0.0.3 24
vrrp vrid 11 virtual-ip 11.0.0.1
vrrp vrid 11 track admin-vrrp interface eth-trunk0.1 vrid 10 unflowdown
vrrp vrid 11 priority 110
arp broadcast enable
#
interface eth-trunk0.3
control-vid 13 dot1q-termination
dot1q termination vid 13
ip address 13.0.0.3 24
arp broadcast enable
#
ip route-static 18.0.0.2 255.0.0.0 eth-trunk0.1 10.0.0.9
#
hot-standby-group local 13.0.0.3 peer 13.0.0.2 src-data-port 4001 dst-data-
port 3001
hot-standby enable
#
return
#
save
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Dual-System HSB Configuration
Figure 7-3, firewall boards
314