Interpreting Panel Displays; Interpreting Status Displays; Alarm And Warning Displays; Hard Wire Base Block Active Display - YASKAWA SGD7S-xxxDA0 series Product Manual

18.1 Interpreting Panel Displays

18.1.1 Interpreting Status Displays

18.1 Interpreting Panel Displays
You can check the Servo Drive status on the panel display of the SERVOPACK.
Also, if an alarm or warning occurs, the alarm or warning number will be displayed.
18.1.1 Interpreting Status Displays
The status is displayed as described below.
Display

18.1.2 Alarm and Warning Displays

If there is an alarm or warning, the code will be displayed one character at a time, as shown
below.
Example: Alarm A.E60
Status Display

18.1.3 Hard Wire Base Block Active Display

If a hard wire base block (HWBB) is active, the display will change in the following order.
Status Display

18.1.4 Overtravel Display

If overtravel has occurred, the display will change in the following order.

Forward Overtravel (P-OT)
Status Display

18.1.5 Forced Stop Display

During a forced stop, the following display will appear.
Status
Display
18-2
Meaning
/TGON (Rotation Detection) Signal Display
Lit if the Servomotor speed is higher than the
setting of Pn502 or Pn581 and not lit if the
speed is lower than the setting. (The default set-
-1
ting is 20 min or 20 mm/s.)
Base Block Display
Lit during the base block state (servo OFF). Not
lit while the servo is ON.
Not lit. Not lit.
Not lit. Not lit.

Reverse Overtravel (N-OT)
Status Display
Not lit. Not lit.
Display
Reference Input Display
Lit while a reference is being input.
Connected Display
Lit while there is a connection.
Not lit. Not lit.
Not lit. Not lit.

Forward and Reverse Overtravel
Status Display
Not lit. Not lit.
Meaning
Not lit.
Not lit.