Table of Contents
Advertisement
4-6
General Setup
The general setup of the UDB-9000 involves selecting the modem address
and transmit power level, adjusting the headphones and speaker volumes,
setting the time and date, adjusting the touch screen display backlight and
contrast, configuring the power saver and the serial ports, and selecting the
audible beep and units preferences. Altogether these adjustments and
selections are made from the Status and Control bar and the Display screen.
The Status and Control bar is shown in Figure 4-5 on page 4-5, and the
Display screen, in Figure 4-2 on page 4-3.
Selecting the Local
Modem Address
The local modem is the modem
function of the UDB-9000. Like any
acoustic telemetry modem it includes a
modem address. This address can be
any address; however, it should be
different than any remote modem in the
communications network.
To select the local modem address:
1. Touch the Modem Address control
on the Status and Control bar, or
touch the Modem Config function button.
The Modem Config screen opens
to the Deck Box tab as shown in
Figure 4-6.
2. Touch the Local Address setting.
The modem address keypad opens
as shown in Figure 4-7.
3. Enter the local modem address,
two characters maximum, and
then touch OK. To backspace and
delete a character, touch the
Delete pad.
4. Touch Exit to close the Modem
Config screen.
User's Manual
TELEDYNE BENTHOS
Figure 4-6 Modem Config
Screen—Deck Box Tab
Figure 4-7 Modem Address
Keypad
P/N M-270-10, Rev. B
Advertisement
Table of Contents
