UDB-9000 Universal Deck Box - UDB-9000-M (Portable) and UDB-9000-MR (Rack Mount) Configurations
The Remote A tab is shown in
Figure 4-37 on page 4-28.
3. Touch the Address setting.
The address keypad opens as
shown in Figure 4-38.
4. Enter the remote modem address,
two characters maximum, and
then touch OK. To backspace and
delete a character, touch the
Delete pad.
The keypad closes and the
address is displayed as the
Address setting.
5. If desired, select the remote modem address for one or both of the
remaining tabs.
Sending Commands to an Instrument that is
Connected to a Remote Modem
Similar to being online with a remote modem as described in the "Acoustic
Telemetry Modems User's Manual," commands can be sent to an instrument,
such as an Acoustic Doppler Current Profiler (ADCP), that is connected to a
remote modem. The command is sent to the modem, and the modem sends
the command to the instrument. Responses from the instrument are sent to
the modem, transmitted to the UDB-9000 and displayed.
To send commands to an instrument that is connected to a remote modem:
1. Touch the tab in the Modem Comms screen for the modem to be
communicated with.
2. To append a carriage return with each command sent, touch Carriage
Return on the tab; to append a line feed, touch Line feed. These
selections are applied to the open tab only.
3. To display the remote modem address with each command sent, touch
Show Address; to display the date and time of the command, touch
Time Stamps. These selections are applied to all three tabs, Modem A,
Modem B and Modem C.
4
Operation using the Touch Screen Display
Figure 4-38 Address Keypad
Communicating with a Remote Modem
4-29