Network Settings - R&S SMB100A Operating Manual

®
R&S SMB100A
Remote command:
:SYSTem:TIME
Time Zone
Selects the time zone.
You can select the time zone according to the major cities on the respective conti-
nents.
Note: By typing the first letter, you can quickly navigate through the lists to find the
desired destination.
Remote command:
:SYSTem:TIME:ZONE
:SYSTem:TIME:ZONE:CATalog?
5.2.3.12

Network Settings

The "Network Settings" dialog shows the parameters relevant for identifying the instru-
ment in a network. The R&S SMB is equipped with a network interface and can be
connected to an Ethernet LAN (local area network).
How to connect the signal generator to the network is described in
"Connecting the Instrument to the
Risk of network errors!
Connection errors can affect the entire network.
If your network does not support DHCP, or if you choose to disable dynamic TCP/IP
configuration, you must assign valid address information before connecting the instru-
ment to the LAN.
Contact your network administrator to obtain a valid IP address.
► To access this dialog, press the SETUP or MENU key and select "Environment >
Network Settings".
Operating Manual 1407.0806.32 ─ 21
on page 446
on page 446
on page 446
Network",
Instrument Function
General Instrument Settings
Chapter 2.6.1,
on page 35.
104