R&S SMB100A Operating Manual page 76

Rf and microwave signal generator

Hide thumbs Also See for SMB100A:

Table of Contents

Generation of an RF Frequency Sweep Signal

In the example, an RF frequency sweep is configured. Proceed as follow:

1. Activate default (preset) state

Press the PRESET key to set a defined instrument state.

2. Configure and activate RF frequency sweep.

a) Turn the rotary knob and select the "RF" block.

b) Press the rotary knob to open the dialog where the RF frequency sweep can be

Operating Manual 1407.0806.32 ─ 21

Getting Started

Example of Setup

Chapters

Table of Contents