Pulse Generator; Pulse Generator Settings - R&S SMB100A Operating Manual

®
R&S SMB100A
The "Dwell Time" set by the user is used as the step time of the sweep. The effective
net dwell time is shorter, reduced by the setting time. This setting time may be greater
than the time specified in the data sheet.
Note:
It is recommended to switch off the display update for optimum sweep performance
especially with short dwell times (see
Remote command:
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:DWELl
Ext. Trigger Input Slope
Sets the polarity of the active slope of an externally applied instrument trigger.
This setting affects the INST TRIG input (BNC connector at the rear of the instrument).
"Positive"
"Negative"
Remote command:
[:SOURce]:INPut:TRIGger:SLOPe

5.5.4 Pulse Generator

The "Pulse Generator" dialog is used to configure and activate a pulse modulation sig-
nal.
5.5.4.1

Pulse Generator Settings

To access the pulse generator settings ...
► Select "Mod Gen > config... > Pulse Generator" or use the MENU key under "Mod
Gen".
Operating Manual 1407.0806.32 ─ 21
Chapter 5.2.3.7, "Display
activates the rising edge of the trigger signal.
activates the falling edge of the trigger signal.
Modulation Generator and LF Output
on page 348
Instrument Function
Update", on page 100).
on page 352
226