Source:power Subsystem - R&S SMB100A Operating Manual

®
R&S SMB100A
Parameters:
<Source>
Example:
Manual operation:
[:SOURce<hw>]:PM:STATe <State>
Activates phase modulation.
Note: Activation of PM deactivates frequency modulation (FM).
Parameters:
<State>
Example:
Manual operation:

7.13.12 SOURce:POWer Subsystem

This subsystem contains the commands for setting the output level, level control and
level correction of the RF signal.
Other units can also be used instead of dBm:
●
by entering the unit directly after the numerical value (example :POW 0.5V)
●
by changing the DEFault unit in the UNIT system (see the command
POWer).
[:SOURce<hw>]:POWer:ALC:OMODe
[:SOURce<hw>]:POWer:ALC:SONCe
[:SOURce<hw>]:POWer:ALC[:STATe]
[:SOURce<hw>]:POWer:ATTenuation:RFOFf:MODE
[:SOURce<hw>]:POWer:EMF:STATe
[:SOURce<hw>]:POWer[:LEVel][:IMMediate][:AMPLitude]
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:OFFSet
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:RCL
[:SOURce<hw>]:POWer:LIMit[:AMPLitude]
Operating Manual 1407.0806.32 ─ 21
INTernal | EXTernal | INT,EXT
INTernal
Uses the internally generated signal for modulation. To configure
the LF signal, use the commands of the
system subsystem.
EXTernal
Uses an externally applied modulation signal.
INT,EXT
Uses both, the internal and external modulation signals.
*RST: INT
PM:SOUR INT
selects the internal modulation source.
See "ɸM Source" on page 207
0 | 1 | OFF | ON
*RST: 0
PM:STAT ON
activates PM.
See "State" on page 207
............................................................................. 377
.............................................................................. 377
............................................................................. 377
...............................................................................378
.......................................................................380
Remote Control Commands
SOURce Subsystem
SOURce:LFOutput Sub-
.........................................................378
..................................................379
........................................................ 379
.............................................................380
:UNIT:
376