Table of Contents
Advertisement
®
R&S
SMB100A
Example:
Usage:
Manual operation:
7.4 CALibration Subsystem
The CALibration system contains the commands for adjustment. Adjustment is trig-
gered by the query commands. The response "0" indicates error-free adjustment, and
the response "1" means that an error occurred during adjustment.
:CALibration<hw>:ALL[:MEASure]?
:CALibration<hw>:FMOFfset[:MEASure]?
:CALibration<hw>:FREQuency[:MEASure]?
:CALibration<hw>:LEVel[:MEASure]?
:CALibration<hw>:LEVel:EXTern:DATA
:CALibration<hw>:ROSCillator[:DATA]
[:SOURce]:CALibration:STEReo:ANALog[:MEAS]?
:CALibration<hw>:ALL[:MEASure]? [<Force>]
Starts all internal adjustments that do not require external measurement equipment.
Query parameters:
<Force>
Return values:
<Measure>
Example:
Usage:
Manual operation:
:CALibration<hw>:FMOFfset[:MEASure]?
The command starts all adjustment for the FM/PhiM modulator.
Return values:
<Measure>
Example:
Usage:
Operating Manual 1407.0806.32 ─ 21
SYST:FPR
All instrument settings (also the settings that are not currently
active) are reset to the factory values.
Event
See
"Factory Preset"
on page 120
................................................................................. 286
.........................................................................286
......................................................................287
...............................................................................287
............................................................................287
............................................................................. 288
string
select
CAL:ALL:MEAS?
// Response "0"
// Adjustment has been performed successfully
Query only
See
"Adjust All"
on page 93
0 | 1
CAL:FMOF?
starts the adjustments for the FM/Phim modulator.
Response: "0"
the adjustments have been performed successfully
Query only
Remote Control Commands
CALibration Subsystem
........................................................... 288
286
Advertisement
Chapters
Table of Contents
