R&S SMB100A Operating Manual page 121

®
R&S SMB100A
Remote command:
:SYSTem:COMMunicate:NETWork[:COMMon]:WORKgroup
Address Mode
Selects the mode for assigning the IP address.
"Auto (DHCP)"
"Static"
Remote command:
:SYSTem:COMMunicate:NETWork:IPADdress:MODE
IP Address
Displays the IP address.
By default, the R&S SMB is configured to use dynamic TCP/IP configuration and to
obtain the whole address information automatically.
If the network does not support DHCP or the attempt does not succeed, the instrument
tries to obtain the IP address via Zeroconf (APIPA) protocol. IP addresses assigned via
Zeroconf start with the number blocks 169.254.*.*.
Note: An IP address that is assigned via the Zeroconf protocol while the network
requires an IP address assigned via the DHCP server may cause network connection
failures.
See
To assign the IP address manually, select
Remote command:
:SYSTem:COMMunicate:NETWork:IPADdress
Subnet Mask
Displays the bit group of the subnet in the host identifier.
To assign the subnet mask manually, select
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:SUBNet:MASK
Default Gateway
Displays the gateway address.
To assign the gateway address manually, select
This address identifies the router on the same network as the instrument that is used to
forward traffic to destinations beyond the local network.
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:GATeway
DNS Suffix
Displays the primary DNS (Domain Name System) suffix, that means the DNS name
without the host name part.
Operating Manual 1407.0806.32 ─ 21
Assigns the IP address automatically, provided the network supports
DHCP (Dynamic Host Configuration Protocol)
The network used must support automatic assignment of the IP
address via DHCP or APIPA (Zeroconf) in order to use this function.
Enables you to assign the IP address manually.
Chapter 9.5, "Resolving Network Connection
Instrument Function
General Instrument Settings
on page 438
on page 439
Failures", on page 487.
Address Mode "Static".
on page 439
Address Mode "Static".
Address Mode "Static".
on page 439
on page 440
106