Trigger<Hw>:Fsweep:source - R&S SMB100A Operating Manual

®
R&S SMB100A
Table 7-2: Cross-reference between the manual and remote control
R&S name
AUTO
SINGle
EXTernal
EAUTo
:TRIGger<hw>:FSWeep:SOURce
:TRIGger<hw>:FSWeep[:IMMediate]
:TRIGger<hw>:LFFSweep
:TRIGger<hw>:LFFSweep:SOURce
:TRIGger<hw>:LFFSweep:IMMediate
:TRIGger<hw>:PSWeep:SOURce
:TRIGger<hw>:PSWeep[:IMMediate]
:TRIGger<hw>[:SWEep]:SOURce
:TRIGger<hw>[:SWEep][:IMMediate]
:TRIGger<hw>[:IMMediate]
:TRIGger<hw>:FSWeep:SOURce <Source>
Sets the trigger source for the RF frequency sweep.
The names of the parameters correspond directly to the various settings under manual
control. SCPI uses other names for the parameters; these names are also accepted by
the instrument. The SCPI names should be used if compatibility is an important consid-
eration.
An overview of the various names is given in
Operating Manual 1407.0806.32 ─ 21
SCPI name
IMMediate
BUS
EXTernal
-
....................................................................................450
................................................................................451
.............................................................................................. 452
.................................................................................452
.............................................................................. 452
....................................................................................453
................................................................................453
....................................................................................454
................................................................................455
............................................................................................. 455
Table
Remote Control Commands
TRIGger Subsystem
Command under manual con-
trol
"Auto" mode
"Single" mode.
"Ext Single" and "Ext Step" mode.
Use command LFO:SWEep:MODE
to select between the two sweep
modes.
"Ext Start/Stop" mode.
7-2.
450