R&S SMB100A Operating Manual page 179

®
R&S SMB100A
Increment value
Sets the increment for the frequency or the level entries.
Remote command:
n.a.
Fill
Fills the selected column in the set range with values, starting with the start value and
using the set increment.
Remote command:
n.a.
Filling the Correction List with Power Sensor Measurement Data
The level correction values for the user correction list can be acquired by means of
R&S NRP power sensors. The R&S NRP sensors are connected to either the
SENSOR connector or to one of the USB interfaces. Configuration of the connection is
performed in the "Power Sensor" menu (see
on page 166). The filling of the user correction list with measurement data is per-
formed in the ucor list editor (see
on page 159).
In the editor, the frequencies for which the correction values are to be acquired are
entered in the frequency column (either manually or by means of the "Fill..." menu).
Do not save the list at this point, because the frequency entries are lost as long as
there are no entries for the level column also. In the following these entries are auto-
matically acquired by the connected power sensor.
All level correction values for the given frequency values are measured using the
Power Sensor and automatically filled in the selected list after the "Execute" button is
pressed. The list is automatically stored and recalled again after filling.
Fill User Correction Data with Sensor Settings
The "Fill with Sensor" button of the "Edit User Correction Data" menu opens the asso-
ciated menu.
This dialog describes all parameters for filling a table automatically with sensor read-
ings.
Operating Manual 1407.0806.32 ─ 21
Chapter 5.3.6.1, "NRP-Z Power
"Edit User Cor. Data - User Correction"
Instrument Function
RF Block
Viewer",
164