R&S SMB100A Operating Manual page 427

®
R&S SMB100A
[:SOURce]:STEReo:AUDio:PREemphasis:STATe <State>
Activates the use of preemphasis for signal generation.
Parameters:
<State>
Example:
Options:
Manual operation:
[:SOURce]:STEReo:AUDio[:FREQuency] <Frequency>
Sets the frequency of the LF generator signal. The command is an alias to command
SOURce:LFOutput:FREQuency.
Parameters:
<Frequency>
Example:
Options:
Manual operation:
[:SOURce]:STEReo:DIRect <Direct>
Sends a R&S SMB command string to the stereo coder. The direct commands offer
extended settings possibilities for the stereo coder (see
mands for the Stereo/RDS Coder Option R&S
Parameters:
<Direct>
Example:
Options:
Operating Manual 1407.0806.32 ─ 21
0 | 1 | OFF | ON
*RST: OFF
STER:SOUR LFG
The internal LF generator is used as modulation source for the
audio signal.
STER:AUD:PRE 50µs
sets preemphasis to 50µs.
STER:AUD:PRE:STAT ON
activates preemphasis.
R&S SMB-B5
See "Preemphasis - Stereo Modulation"
float
Range: 0.1 to 1E6
Increment: 0.01
*RST: 1000
STER:SOUR LFG
The internal LF generator is used as modulation source for the
audio signal.
STER:AUD:FREQ 1100
sets the frequency of the audio signal to 1.1 kHz
R&S SMB-B5
See "LF Gen Freq - Stereo Modulation"
string
STER:DIR 'ARI-ID=0'
deactivates the ARI identification.
R&S SMB-B5
Remote Control Commands
SOURce Subsystem
on page 214
on page 214
Chapter 7.19, "Direct Com-
SMB-B5", on page 456).
412