Stereo Modulation Dialog - R&S SMB100A Operating Manual

Rf and microwave signal generator

Hide thumbs Also See for SMB100A:

Table of Contents

A typical setup with the R&S SMB with the option Stereo/RDS Coder in connection

with the Audio Analyzer UPV is shown in the following graph.

Stereo Modulation Dialog

To open the "Stereo Modulation" dialog, select "Modulation > Configure > Stereo Mod-

ulation" or use the MENU key under "Modulation".

In the upper section of the menu, the stereo modulation is configured and switched on.

The configuration and activation of the additional pilot tone, ARI and RDS settings is

performed in the lower section of the dialog.

Operating Manual 1407.0806.32 ─ 21

Instrument Function

Table of Contents