Sense<Ch>[:Power]:Offset; Sense<Ch>[:Power]:Offset:state; Sense<Ch>[:Power]:Snumber - R&S SMB100A Operating Manual

®
R&S SMB100A
Example:
Manual operation:
:SENSe<ch>[:POWer]:OFFSet <Offset>
The command enters a level offset which is added to the measured level value after
activation with command SENSe[:POWer]:OFFSet:STATe ON. This allows e.g. an
attenuator in the signal path to be considered.
Parameters:
<Offset>
Example:
Manual operation:
:SENSe<ch>[:POWer]:OFFSet:STATe <State>
The command activates the addition of the level offset to the measured value. The
level offset value is set with command SENSe[:POWer]:OFFSet.
Parameters:
<State>
Example:
Manual operation:
SENSe<ch>[:POWer]:SNUMber?
The command queries the serial number of the sensor.
Return values:
<Snumber>
Example:
Usage:
Manual operation:
Operating Manual 1407.0806.32 ─ 21
SENS:SOUR USER
selects user-defined source.
SENS:FREQ 2.44 GHz
enters the RF frequency of the source which is 2.44 GHz.
See "Frequency" on page 171
float
Range: -100.0 to 100.0
*RST: 0
Default unit: dB
SENS:POW:OFFS 10.0
sets a level offset of 10 dB
See "Level Offset" on page 171
0 | 1 | OFF | ON
*RST: OFF
SENS1:POW:OFFS 0.4dB
sets a level offset of 0.4 dB
SENS1:POW:OFFS:STAT ON
a level offset of 0.4 dB is added to the measured value.
See "Level Offset" on page 171
string
SENS:SNUM?
queries the serial number.
Query only
See "Current Sensors"
Remote Control Commands
SENSe, READ and INITiate Subsystems
on page 98
322