Diagnostic Subsystem - R&S SMB100A Operating Manual

®
R&S SMB100A
Example:
Manual operation:
:CALibration<hw>:ROSCillator[:DATA] <Data>
Sets the calibration value for the custom defined external adjustment.
Parameters:
<Data>
[:SOURce]:CALibration:STEReo:ANALog[:MEAS]?
The command starts all adjustments which affect the analog channels of the stereo
coder option.
Return values:
<Meas>
Example:
Usage:
Options:
Manual operation:

7.5 DIAGnostic Subsystem

The DIAGnostic system contains the commands used for instrument diagnosis and
servicing. SCPI does not define any DIAGnostic commands; the commands listed here
are all device-specific. All DIAGnostic commands are query commands which are
not influenced by *RST.
:DIAGnostic<hw>:BGINfo?
:DIAGnostic<hw>:BGINfo:CATalog?
:DIAGnostic:INFO:OTIMe?
:DIAGnostic:INFO:POCount?
:DIAGnostic<hw>:BGINfo? [<Board>]
Checks the modules available in the instrument using the variant and revision state.
Operating Manual 1407.0806.32 ─ 21
CAL:LEV:EXT:DATA FACT
selects the use of the data aquired at the factory for external
level correction.
See "Adjustment Data"
integer
Range: 0 to INT_MAX
*RST: 0
0 | 1
CAL:STER:ANAL?
starts the adjustments for analog channels of the stereo coder.
Response: 0
the adjustments have been performed successfully.
Query only
R&S SMB-B5
See "Adjust Stereo Coder"
..............................................................................................288
................................................................................ 289
..............................................................................................289
.......................................................................................... 290
Remote Control Commands
DIAGnostic Subsystem
on page 151
on page 94
288