Table of Contents
Advertisement
®
R&S
SGS100A
Start the version that is required for your application.
Uninstalling an old software version
An uninstallation of a previous version of the SW can be performed before the
installation of the new one, but this is not mandatory.
► To uninstall this version, go to "Start > Settings > Control Panel > Add/
Remove Programs" and select the entry SGMA-GUI_V.VV.VVV.VVV.
The script file identifies and removes all currently installed R&S SGMA-GUI
software items.
2.3.2
Connecting a Remote PC via LAN
The R&S SGS is equipped with a network interface and can be connected to an
Ethernet LAN (local area network). The interface can be used, for example:
● To connect an external computer for manual control of the instrument by the
R&S SGMA-GUI software.
● To operate the device by a remote control program.
See
Chapter 5.2, "Network and Remote Control
This section describes how to configure the LAN interface. It includes the follow-
ing topics:
●
Chapter 2.3.2.1, "Connecting the Instrument to the
●
Chapter 2.3.2.2, "Assigning the IP
●
Chapter 2.3.2.3, "Automatically Adding Instruments to the SGMA-GUI
on page 22
2.3.2.1
Connecting the Instrument to the Network
There are two methods to establish a LAN connection to the instrument:
● A non-dedicated network (Ethernet) connection from the instrument to an
existing network.
● A dedicated network connection (Point-to-point connection) between the
instrument and a single computer.
In both cases, an IP address has to be assigned to the instrument and the com-
puter, see
Chapter 2.3.2.2, "Assigning the IP
Getting Started 1416.0570.02 ─ 11
Connecting an External PC and Devices
Operation",
Address",
on page 21
Address",
Preparing for Use
on page 40.
Network",
on page 19
on page 21.
",
19
Advertisement
Table of Contents
